[Automated-sequencing] Re: Need help with 3700 computer

Duncan Clark blackhole at abuse.plus.com
Fri May 19 05:52:02 EST 2006


Historians believe that in newspost 
<mailman.1020.1147887328.16885.autoseq at net.bio.net> on Wed, 17 May 2006, 
Paul Shinn <shinn at salk.edu> penned the following literary masterpiece:
>When I install Collection after that and try to start up
>collection, after rebooting and logging in, I get a message that one or
>more services has not started.

Never used the 3700 or it's software but it is possible that various 
bits are now no longer set to autostart as a service when the computer 
boots.

Assuming Win2K

Make a note of the service name, if it gives one, then as administrator 
to the computer go to control panel, open administrative tools then 
Services.

Go down the list and see if your names are there. If so I bet it/they 
say(s) Startup type is manual. Right click on each name and select 
properties and alter Startup type on the General tab to automatic or in 
the first instance just start them. If the 3700 software will now run 
you can go back and change them to automatic.

If the service is not there then it means the software has not installed 
them and there is nothing I can suggest further other than an engineer 
or a user that knows what to do.

Good luck

Duncan
-- 
I love deadlines. I especially like the whooshing noise they make as
they go flying by.

Duncan Clark
GeneSys Ltd.



More information about the Autoseq mailing list