CCP4 Compiling Problem

Clemens Vonrhein vonrhein at
Sat Apr 4 12:56:55 EST 1998

In article <6finbd$8c5 at>, steffen at crystal (Steffen Graether) writes:
> Johannes Ullrich (jullrich at wrote:
> : maybe you don't have f77 (or g77) installed right? I recommend going through
> : the install again. RedHat does not install f77/g77 (or fort77) by default. The
> : installation procedure is a bit elaborate but not too bad if you follow the
> : instructions religiously.
> I installed the compilers using RedHat rpms (distributions that basically 
> configure themselves). Anyone know of any problems with using the defaults?
> : BTW: most of ccp4 can be compiled using f2c.
> I was successful with compiling libdir and datadir, but srcdir choked (I 
> have to check into that one).

We're running RedHat 5.0 on Alpha/Linux (glibc). As compiler we use
egcs-1.0.2 ( I use the following flags: 

FOPTIM = -O5 -fomit-frame-pointer -funroll-loops -ffast-math -finline-functions -Wall
COPTIM = -O5 -Wall
XFFLAGS = -fno-second-underscore
SETFLAGS = dm_FLAGS='-O0 -fno-second-underscore -funroll-all-loops -fschedule-insns'

There we're some things that had to be changed to compile. Perhaps you
should wait for the next relaese (end of April?). The CCP4 people are
making an effort to get decent g77 support.


* Clemens Vonrhein   email vonrhein at           *
*                    WWW  *
*                                                                         *
*         Institut f. Org. Chemie u. Biochemie                            *
*         Albertstr.21                                                    *
* D-79104 Freiburg i.Br. (Germany)                                        *
*  Tel.: 761/203-6061   FAX: 761/203-5987                                 *

More information about the Xtal-log mailing list