maybe you don't have f77 (or g77) installed right? I recommend going through
the install again. RedHat does not install f77/g77 (or fort77) by default. The
installation procedure is a bit elaborate but not too bad if you follow the
instructions religiously.
BTW: most of ccp4 can be compiled using f2c.
Johannes.
Steffen Graether wrote:
> Steffen Graether (steffen at crystal) wrote:
> : Hello,
>> : We are trying to compile ccp4 under red hat linux 4.1. I've found
> : the very helpful webpage, but I think I've run into a (simple?) compiler
> : problem:
> : FC="f77" CC="gcc" XFFLAGS="-fno-second-underscore" FOPTIM="-O" XLDFLAGS=
>> Several people have written that the problem might be that I have f77
> instead of g77. That was actually the first way I had it set up. I
> changed it to f77 since both files exist on our computer and I had hoped
> that things would correct themselves automagically. It didn't.
>> It was also suggested that I try fort77 and compile it more directly via
> gcc. I'll see if that will work.
>> Many thanks for the help so far.
>> Steffen (full e-mail address is below)
>> --
> *************************************************************************
> * * *
> * Steffen Graether * steffen at crystal.biochem.queensu.ca *
> * * *
> *************************************************************************
--
_____ jullrich at iname.com ______________________________________________
|
Johannes Ullrich | phone: (518) 427 5928 (home)
323 State Street Apt. 7 | (518) 464 3334 (work)
Albany, NY 12210 |
| WWW: http://johannes.ml.org
____________________________|__________________________________________
